Hello Guest it is March 28, 2024, 05:56:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mobob

Pages: 1
1
Hi everyone, I have been using Mach2 for sometime on a co-ordinate table I converted to cnc operation. I am using a Simplycnc 2500 control. My problem is that now I have up-graded to Mach3 all the directions have reversed. I have next to no electronic knowledge and am stuck on what to do. I would appreciate any help regards Mobob

Pages: 1