Hello Guest it is August 08, 2020, 02:24:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ign cover

Pages: 1
1
General Mach Discussion / Re: set up
« on: December 01, 2006, 11:31:56 PM »
Thanks
 did the motor fine tuning and things look  a lot better

2
General Mach Discussion / set up
« on: November 29, 2006, 11:28:30 PM »
Hi
got a taig with xylotech  4 axis controller, settin' it up , having problems , the nc files files appear to be scaled down in the graphic screens and when I was running them, tried scaling at the dro's but some of the geometry gets screwed up, then I discovered in the settings screen above the reset button the axis calibration.hooked up a indicator on x and y axis and movement was for .100" only .0075 so i accepted the new steps per unit , tried it again looked better but circles are oval and some other strange things happening,
only running the trail mach3 version , is that the problem? need some help

Pages: 1