Messages

1

Tangent Corner / Re: Looking for a plug

« on: May 02, 2013, 08:56:09 AM »

Thanks Jef,

I see I can pay you through PayPal. If I do that you will have my full address as well.

Roger

2

Tangent Corner / Re: Looking for a plug

« on: May 01, 2013, 04:51:51 PM »

Hi Jef,

Yes Just the plug as in the picture. If you could figure a price including mailing to Canada N6C 2R2 we could figure out how to get payment to you.

No name seemed easier than describing the ToolTech from Cyber-NC CNC that has long been out of business.

Thanks,

Roger Muma
roger@mumaharps.com

3

Tangent Corner / Looking for a plug

« on: May 01, 2013, 02:03:34 PM »

Perhaps someone can help me identify this plug by Phoenix connect. Any info about where I might obtain another one of these would be welcome. Being, I hope, a standard CNC control connector I thought this might be the right place to ask. I want to connect a probe to my no name control box.

Thanks

Roger Muma

4

General Mach Discussion / Problem with set up

« on: July 03, 2011, 01:01:31 PM »

I have had to reinstall Mach 3 -- upgraded computer and OS, now have XPsp3. Thought I would upgrade to lateset version. Now after setting up a couple of times the  DRO's which are meant to be accurate show no relationship to my table. (CNC router). instead of 48 x 24 x 6 inches they are showing for a machine which is about 3 times larger. Never have had this problem before and see not solution.

Desperat to get back in business. Not a hobby type of guy--just want it to work again.

Thanks

Roger