1
General Mach Discussion / Re: What CAD system to use with MACH3 & LazyCam
« on: September 22, 2008, 03:59:41 PM »
Hi Kristin,
Thanks for the reply, I suppose that the main question is: what CAD software do other people use that can output to Mach3? I Understand about the Z axis control but not how the cad software outputs to Mach3 or LazyCam.
Cheers
Dave
Thanks for the reply, I suppose that the main question is: what CAD software do other people use that can output to Mach3? I Understand about the Z axis control but not how the cad software outputs to Mach3 or LazyCam.
Cheers
Dave