1
General Mach Discussion / Re: Works in KCam, Not working in Mach3
« on: March 01, 2007, 02:16:48 AM »
Dear Brian,
I bought my driver via Ebay. Here is the link :
http://cgi.ebay.com/4-AXIS-CNC-ROUTER-OR-MILL-STEPPER-MOTOR-DRIVER-BOARD_W0QQitemZ230098501074QQihZ013QQcategoryZ78196QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
This driver is based on Allegro A3977 driver chip and it has 6N136 Optocoupler. As you know 6N136 is 1 Mbit/sec opto and quite fast to control signals. I don't know what the problem is but i can use it in Mach3 trial
Cooper
I bought my driver via Ebay. Here is the link :
http://cgi.ebay.com/4-AXIS-CNC-ROUTER-OR-MILL-STEPPER-MOTOR-DRIVER-BOARD_W0QQitemZ230098501074QQihZ013QQcategoryZ78196QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
This driver is based on Allegro A3977 driver chip and it has 6N136 Optocoupler. As you know 6N136 is 1 Mbit/sec opto and quite fast to control signals. I don't know what the problem is but i can use it in Mach3 trial
Cooper