Messages

1

General Mach Discussion / Re: Spindle configuration problem

« on: September 21, 2008, 04:33:42 PM »

I use AutoCal in spindle calibration window. When calibration ended I have checked spindle work. It has absolutely ceased to work! At any RPM on the voltmeter 9,97V.

2

General Mach Discussion / Re: Spindle configuration problem

« on: September 21, 2008, 02:00:25 PM »

No result...

3

General Mach Discussion / Re: Spindle configuration problem

« on: September 21, 2008, 01:35:55 PM »

Yes, but there are no changes. I have returned to standard options. I use PWM control, no step/dir.

4

General Mach Discussion / Re: Spindle configuration problem

« on: September 21, 2008, 01:20:51 PM »

If I input less 8000 RPM then Mach gives out the message "PWM Bumped to minimum setting".

5

General Mach Discussion / Re: Spindle configuration problem

« on: September 21, 2008, 01:10:58 PM »

First pulley. All others are identical.

6

General Mach Discussion / Re: Spindle configuration problem

« on: September 21, 2008, 01:02:55 PM »

Thanks for you answer. I did it, but there is no result. In pulley selection I have Min 1000 and Max 24000 RPM

7

General Mach Discussion / Spindle configuration problem

« on: September 21, 2008, 08:52:28 AM »

Dear friends. Sorry, but my English is not good. I have a problem with Mach PWM spindle control. I use ncPod board and it work perfect. I connect PWM to Digital converter and config Mach. After them I connect voltmeter to PWM converter output (0-10V) and I have controling voltage. If I input in Mach 18000 rpm I view 9.97V on voltmeter. But my spindle max 24000 rpm! Also I input less 8000 rpm then view on voltmeter 0V. I dont find spindle preferences in Mach. Where is I input min and max spindle rpm?