Hello Guest it is March 28, 2024, 09:34:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Steve

Pages: 1
1
General Mach Discussion / Re: Mach-3
« on: November 28, 2005, 07:10:22 PM »
I would like to thank mikezcnc & barker806 for your good answers to my question. i did not think it was so hard
of a problem?  Over the years I have sent many people good information about a problem they were having
even if I  thought they were lazy but sent them anyway.

Is this forum about solving problems or busting balls?

Sorry for my bad spelling and grammer.

                   Steve

2
General Mach Discussion / Re: Mach-3
« on: November 26, 2005, 03:30:07 PM »
Thank's Art
I hope someone has this file
                        Thanks Steve

3
General Mach Discussion / Mach-3
« on: November 26, 2005, 01:55:38 PM »
Hello
I am running a K2 39-25 router with Mach-2  servo system
I would like to go over to Mach-3 My question is does anybody have a conf. file that works
I am having a problem transferring the set-up file?


                    Thanks Steve

Pages: 1