Hello Guest it is March 28, 2024, 08:39:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marcolagares

Pages: 1
1
General Mach Discussion / Re: Spindle output not function
« on: September 20, 2008, 09:59:41 AM »
Problem solved! It was a malfunction in the Cmos of BreakoutBoard.

Thank you any way

2
General Mach Discussion / Spindle output not function
« on: September 19, 2008, 12:27:01 PM »
I to all can´t figured why spindle relay don´t start when i press spindle button and m3 or m5 function. At ports and pins i have set output enable port 1 pin number 2 and in the Spindle Setup tab i unchecked Disable Spindle relays. At the diagnostics everything work fine. The only way that i put it to work is set the Active low on at the outputs tab , but then the only way to stop it is cut the power.Any suggestion?

  Thanks in advance

Marco

Pages: 1