1
General Mach Discussion / Re: Mach2 to Mach3
« on: December 02, 2006, 04:55:57 PM »
Hood
I have corrected some wrong pin settings and the axis seem to be moving correctly.
But I cannot get the spindle to run. I have the comport set but Mach3 doesn't talk to the VDF.
Also the VDF is set so that 400 Hz = 24000 rpm, will Mach3 convert spindle speed comands to a matching Hz output.
Thanks
Chuck
I have corrected some wrong pin settings and the axis seem to be moving correctly.
But I cannot get the spindle to run. I have the comport set but Mach3 doesn't talk to the VDF.
Also the VDF is set so that 400 Hz = 24000 rpm, will Mach3 convert spindle speed comands to a matching Hz output.
Thanks
Chuck