Hello Guest it is December 01, 2021, 02:53:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - compositepro

Pages: 1
1
General Mach Discussion / Re: 25khz maximum
« on: November 27, 2006, 03:18:25 PM »
i just heard the grex uses usb or eternet

thats why i was asking

2
General Mach Discussion / Re: 25khz maximum
« on: November 27, 2006, 12:28:24 PM »
driver test says 23782 does driver test test in 35khz and 45khz mode

does the demo do mach 4

im puzzled if i was to buy a license as my gcode is way more than 1000 line limit

do i buy a license for mach 4 im looking into getting grex

plus the new pc has a kentsfield processor and there arent many boards that have a parralel port


3
General Mach Discussion / Re: 25khz maximum
« on: November 26, 2006, 03:22:53 PM »
thanks for that i found out also im only running demo

hardware is not really a problem its a 3ghz quad xeon workstation(i do lots of cad design)

4
General Mach Discussion / 25khz maximum
« on: November 26, 2006, 02:15:30 PM »
whats the relevance of 25khz

i read there are two settings 25khz and 45 khz am i wrong

drivertestnever goesabove 24khz

5
General Mach Discussion / Re: mach 3 and vista
« on: November 22, 2006, 05:26:43 PM »
ok art reinstall under windows xp sp2 compatibility mode  runs then just hangs so reboot in order

then

LOW AND BEHOLD

SYSTEM UNDER MACH 3 CONTROL

pulses 24069- 24093

cpu speed1894

apic timing 4142

mach test complete


OK

whats dinput8dll

6
General Mach Discussion / Re: mach 3 and vista
« on: November 22, 2006, 05:13:29 PM »
hey art it install ok

on the rc2release ihad a dll the wouldnt install at all

i understand theres some issue about about how it controls the xp process well windowsvista lets you run in xp compatibility mode so maybe

in fact back soon when ive tried that

7
G-Code, CAD, and CAM discussions / edgecam post
« on: November 22, 2006, 04:22:46 PM »
has anyone mastered this or do i have to start from scratch

8
General Mach Discussion / Re: mach 3 and vista
« on: November 22, 2006, 04:20:52 PM »
correct art my fault

 it runs ok as sim though

should'nt be too much of a problem to fix eh??

9
General Mach Discussion / Re: mach 3 and vista
« on: November 22, 2006, 02:51:13 PM »
yep build 6000 which is vista final release available early on MSDN

only problem i had was a dll which would'nt register due to microsofts funky new file protection system but once that was taken care of all runs fine

however having used vista from beta onwards i will tell you stick with xp Vistas just anew toy its not really geared towards us cnc typesand tobe honest im growing tired of fighting with it whenever i want to install a program

btw anyone know if theres a post for edgecam

10
General Mach Discussion / mach 3 and vista
« on: November 22, 2006, 12:24:16 PM »
seems to work

Pages: 1