Messages

1

General Mach Discussion / Re: Limit / Home Switches

« on: October 06, 2013, 02:30:46 PM »

No There is adifferent wire going to each of the connections on the micro switch. The shield is braided with a wire going to the board ground which I am going to change to case/earth ground.

2

General Mach Discussion / Re: Limit / Home Switches

« on: October 06, 2013, 02:24:56 PM »

No  I have a wire going to each of the connections on the micro switch and the shield is a different wire attached to the braiding.

3

General Mach Discussion / Re: Limit / Home Switches

« on: October 06, 2013, 07:57:15 AM »

I don't think it is the ground . I think I found a programing error. I will check that later today. Thanks

4

General Mach Discussion / Re: Limit / Home Switches

« on: October 06, 2013, 07:55:27 AM »

I will move it Thanks

5

General Mach Discussion / Re: Limit / Home Switches

« on: October 06, 2013, 07:51:34 AM »

Connected to the ground on the C11 break-out board on the limit switches

6

General Mach Discussion / Re: Limit / Home Switches

« on: October 06, 2013, 06:07:07 AM »

I have the  Debounce Interval set at 2000 and it still will not work the wiring is shielded on both the limit switches and the encoders. I will get the iml and post it if I can.Thank you for your help

7

General Mach Discussion / Limit / Home Switches

« on: October 04, 2013, 09:33:25 PM »

I switched over to servos from stepper motors and the axis will not back off the limit switches. The breakout board is a CNC4PC-C11, with Geckodriver G320X and a KL34-180-72 servo motor. All limit and encoder wires are shielded.
When the axis go to the limit it stops but can not move it off the limit switch. Any ideas. HELP