Hello Guest it is March 28, 2024, 11:26:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - boutje

Pages: 1 2 3 »
1
CS-Lab / Re: Completely lost with my CSMIO IP-m 4
« on: October 09, 2018, 03:39:17 AM »
Which country you from?

2
*****VIDEOS***** / emco 120 cnc retrofit with mach3 cs lab
« on: July 02, 2018, 03:36:03 AM »
Making parts on a emco 120 cnc .
Retrofit with mach3 and cs lab csmio/ip-s

https://youtu.be/S6UvOuwh4uk

3
CS-Lab / Re: Camino/ip-m spindle speed
« on: January 20, 2016, 06:44:31 AM »
The csmio/ip-m did not have any spindle feedback and also not spindle closed loop control.
Only the s and a have that.

4
PoKeys / Re: MPG problem
« on: January 06, 2014, 02:55:50 AM »
Ok, but in the second profile everything in the pokeys setup is the same.
All the buttons are working fine only the mpg not.

5
PoKeys / MPG problem
« on: January 04, 2014, 08:31:56 AM »
I have the following mpg problem with pokeys.

MPG/ pokeys is working fine in mach mill.

But i have also , with the same pokeys mpg pc , running a second profile.

And than the mpg is not working at all.

6
CS-Lab / Re: First impressions of CS-Lab products
« on: July 11, 2013, 01:37:22 PM »
Yes.

7
CS-Lab / Re: First impressions of CS-Lab products
« on: July 11, 2013, 04:03:55 AM »
I had the same problem.
After a reboot with the uploader program the problem was solved.

8
VB and the development of wizards / Re: gear changing possible?
« on: April 04, 2013, 02:59:11 AM »
I have done this with a deckel fp4 cnc.

But i did it with a couple of M codes.

Example:

M13 is 25 rpm
M50 is 50 rpm
...
..

and so on.

Problem with a S code is when you make the wrong S then the gearbox will never find the right gear.
That is why i did it with M codes.

9
I have make it totally different.

Now i have a button to set the feed FRO  on 10%.
When i push the button again the feed FRO is set back on 100%.

This good for now.

10
Thanks for the reply`s.

@Striling,

Nice one!

But there is another issue .
The feedrate is not always 1000mm/min.
I can also be a other value.

Pages: 1 2 3 »