Hello Guest it is August 06, 2020, 09:27:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gianluca1962

Pages: 1 2 »
1
General Mach Discussion / Re: Version R3.042.035 No Go
« on: January 08, 2010, 06:31:48 AM »
Hood,
got the same error, cannot find any shuttlepro.dll in the plugins folder.

regards
Gianluca

2
General Mach Discussion / Re: what am I doing wrong?
« on: December 06, 2008, 05:15:35 AM »
Many thanks Hood,
I have done what You suggested and now the program runs well on the laptop as simulation and I had no problem loading it in full on a desktop,again simulation as no machine in connected.
I am ready now to do the installation on the machine pc.

thanks

Gianluca

3
General Mach Discussion / Re: what am I doing wrong?
« on: December 05, 2008, 07:00:41 AM »
the driver test does not looks good, a message appear 'pulsing too fast'.

this evening will try to install it on a desktop pc

thanks

Gianluca

4
General Mach Discussion / Re: what am I doing wrong?
« on: December 05, 2008, 04:58:31 AM »
Yes, i made a complete installation

Gianluca

5
General Mach Discussion / Re: what am I doing wrong?
« on: December 05, 2008, 04:39:15 AM »
Hood wrote:
Might be an idea to delete everything in the Mach folder and re download Mach and install again.

I have done this yesterday as per Your suggestion, first trial was ok as feed DRo but not actual cicle time.

pc where I'am testing now is a laptop 1.8g with 1 g of ram , ( I know I should not use a laptop but this is the pc where I test blank the program and never had problem with rel 1.84) This evening I may try to update a more powerfull desktop to see if it is the pc

Gianluca

6
General Mach Discussion / Re: what am I doing wrong?
« on: December 05, 2008, 04:19:21 AM »
the feed DRO is between 2 and 3 times the F********* but the actual cicle time is also 2 to 3 time longer of what it should be.
in rapid it also exceeds the max motor speed set

7
General Mach Discussion / Re: what am I doing wrong?
« on: December 05, 2008, 03:01:23 AM »
gcode

8
General Mach Discussion / Re: what am I doing wrong?
« on: December 05, 2008, 02:59:47 AM »
configuration file attached

9
General Mach Discussion / Re: what am I doing wrong?
« on: December 05, 2008, 02:20:33 AM »
Did what Hodd suggested, and something changed but not in the way it was desired.
After the installation the feed DRO stayed within the programmed value but the total cicle time is twice or thee time what it should be.

this morning checked again and the feed speed went sky high again.
what can I do?

Hood I tried to attach the files but the system tells me the these files have already been uploaded but the post is not shown .

gianluca

10
General Mach Discussion / what am I doing wrong?
« on: December 03, 2008, 03:23:31 PM »
just upgraded to last .020 release (for turn) and found that in the feed d.r.o. the value is going sky high instead of keeping the programmed feed.
I copyed and paste the old configuration file .xlm from 1.84.02 version, may be this is the problem?

regards gianluca

Pages: 1 2 »