1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: October 07, 2008, 08:19:59 PM »
Hello!!! mi name is César.
I`m in Argentina retrofitting a little cnc machininng center / lathe using Mach3 + Grex + 4 x G320 drives + PWM Spidle drive.
Motors + drivers + encoders + electric / electronics... OK.
Moves OK, Helical interpolation (3 axes x, y, z) OK.
Spindle speed close loop... No
Spindle speed rpm indicator No
Sync Spindle / z for threading No
Mhhh... I`m thinking... G100 was a bad choice for a lathe.
Thanks for your attention!!!. Sorry for my poor english!!!.
I`m in Argentina retrofitting a little cnc machininng center / lathe using Mach3 + Grex + 4 x G320 drives + PWM Spidle drive.
Motors + drivers + encoders + electric / electronics... OK.
Moves OK, Helical interpolation (3 axes x, y, z) OK.
Spindle speed close loop... No
Spindle speed rpm indicator No
Sync Spindle / z for threading No
Mhhh... I`m thinking... G100 was a bad choice for a lathe.
Thanks for your attention!!!. Sorry for my poor english!!!.