2
« on: August 08, 2011, 03:12:00 PM »
Thanks Kenny
No immediate rush, I'm not quite there with it's install yet, just trying to cover possible problem areas before the conversion point of no return and avoid too much down time. Thanks for the offer of help. I just need to get a 0 to 10V signal for VFD with M3 and M4 relays the same as many mach users operate. Actually just forward M3/M5 on/off spindle motion will do for now.
I did even wonder whether for spindle use, and to save some valuable outputs, whether the Galil was better confgured if possible to use the step/direction signal for spindle direction, and the enable signal to start the spindle. Easy enough then to wire the enable signal steered via a step direction relay to the CW/CCW inputs on a VFD. Not that I've read enough of the Galil stuff to know if that's viable, or viable to mach.
Regards Mark