Hello Guest it is May 28, 2020, 03:48:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - CrashMasterKev

Pages: 1
1
General Mach Discussion / Stepper issue????
« on: December 04, 2006, 06:12:06 PM »
I have a new machine a 24X36 tabletop with geckos and steppers and had it running pretty well,  I was running a program that I had already ran a couple times and it was fine, then I lost steps or what I believe is lost steps in the Y axis and ever since it has not worked right, my X & Z axis’s are working fine (Jogging) but the Y is still acting up, when I try to jog it will go in whatever direction it wants not necessarily the direction I choose to jog.
I swapped the Z and Y motors and that didn’t help, I swapped the Gecko drives  for those axis and no change??
I cant even home it, it just groans..
Any ideas???
Thanks in advance.
Kevin



Pages: 1