1
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: April 10, 2014, 06:26:50 AM »
I have been having problems getting the NF threading wizard to work. I have tried most things mentioned in these threads with no luck.
In the end I edited the G76 macro and all I did was change the "test = false" to "test =true" and everything worked like a dream.
That's all I did.
Before that I tried changing the amount of time the index signal was on and all the other things suggested here in others posts.
When I figured it must have been in the macro was when the lathe did the same faults wether the index was set in the spindle configuration or not.
Hope this helps someone.
In the end I edited the G76 macro and all I did was change the "test = false" to "test =true" and everything worked like a dream.
That's all I did.
Before that I tried changing the amount of time the index signal was on and all the other things suggested here in others posts.
When I figured it must have been in the macro was when the lathe did the same faults wether the index was set in the spindle configuration or not.
Hope this helps someone.