Hello Guest it is March 28, 2024, 07:28:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hato

Pages: 1
1
General Mach Discussion / Autocalibrate spindel
« on: November 05, 2013, 10:29:20 AM »
I set up Spindle Pully 1 Ratio to 4 but when I use Auto calibrate the field  "Pulses Per Revolution, Zero if 1 pulse per rev" is still zero.
How can I change zero to 4?

2
General Mach Discussion / Re: Dwell is blinking
« on: November 05, 2013, 10:13:26 AM »
Thank You for the answer.
If i changed the speed then the dwell stop flashing.

3
General Mach Discussion / Dwell is blinking
« on: October 27, 2013, 01:25:13 PM »
I´m rather new user of Mach 3. an I' m trying to calibrate the spindel.
I  control the speed and read the speed from mach 3, that's ok.
But when I tried to calibrate the spindel using Autocalibrate, then the spindel stop.
After that it's impossible to start the spindel again and the Dwell is flashing.
What could had happened and how do I reset this?
Need Your help!

Pages: 1