Hello Guest it is March 29, 2024, 09:02:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Nao

Pages: 1
1
Mach3 and G-Rex / Cannot send firmware.(no web page shown)
« on: July 12, 2008, 11:43:25 AM »
Hello. I bought a G100 (serial number? E8).
I connected G100 with my computer with a cross over cables.
At first, I could see the firmware upload pages on my web browser.
But after sending a latest firmware, I cannot connect to the G100.
I checked with my straight cables with switching hub, and USB cables.

Using Grex-loader, I can find G100's IP address and computer IP address.
I turned off my firewall, reset my computer, switch on and off my G100
again and again,,, but I cannot see the firmware pages.

Also, I cannot ping to G100, nor I cannot recognise G100 from MACH3 software.

G100 IP address is now 192.168.0.10. But I tried to change it to 192.168.100.1
and 192.168.200.10 etc... but in vain.   :'(

Can anyone give me some advice?
Naomichi

Pages: 1