1
General Mach Discussion / Re: new user : keeping old (2000) servo drive with mach 3
« on: July 09, 2008, 09:44:52 AM »
I will post pics of the machine tomorrow it will clear thing up.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
no it's not difficult , time consuming maybe !.
i am not familiar with the machine you have but we should be able to advise and walk you through
email me off list if you wish
where are you based ?
Dave
Not sure what you mean but if its can it be done then yes it can, will it work as good as before then yes it should and probably better. I have a large lathe from 1981 that I have retrofitted and its used daily and no problems.
Hood