Hello Guest it is March 29, 2024, 03:59:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Johannescnc

Pages: 1
1
General Mach Discussion / Re: Limit switches
« on: November 28, 2008, 11:22:28 AM »
Thanks for your input... this sounds very reasonable. because when I am homing I jog close to home...

2
General Mach Discussion / Limit switches
« on: November 28, 2008, 10:46:52 AM »
 I have had some problems with my limit switches and seems not an uncommon problem. So by process of elimination I found that if I only use them for homing, they work fine. but when they are used for homing and limit, I get frequent limit trip errors.
 Have not needed my limit switches at this point but may find a need latter as I gain knowledge with experience.
 

3
LazyCam (Beta) / Re: trouble posting code
« on: October 23, 2008, 07:43:08 AM »
backing up my files is not the issue... BUt have resolved to using an alternative in CamBam... Works great!  ;D

4
LazyCam (Beta) / Re: trouble posting code
« on: October 20, 2008, 07:46:00 PM »
I have a license under the latest Mach3 build and of course the beta Lcam. I had a file I worked on that was ok and after making some changes it would not post the edited code. just before this ity had locked up and needed a reboot of my system... :o
   Gonna try to work on a dxf upload to see if it works for this.

5
LazyCam (Beta) / Re: trouble posting code
« on: October 20, 2008, 03:43:50 PM »
I have the same issue...

6
General Mach Discussion / Re: hooking up limits
« on: September 04, 2008, 11:31:14 AM »
Great tip on the 24v signals...

Pages: 1