1
General Mach Discussion / Re: new user - No signal to board - I think?
« on: October 07, 2006, 11:53:12 AM »
Thank you Hood
I went out and tried to uncheck the estop but after clicking apply and then ok I tried the reset button and it would not reset. So I went back and checked my estop setting and it was checked with a green check so I unchecked it again now showing a red x click apply and ok again then clicked the rest and it would still not reset. So I opened it again and it had changed itself bach to a green check. So I unchecked it again still the same thing happened.
Any thoughts?
I see that you suggested I look at the vidio and I will do that thanks again.
Thanks
Mike
I went out and tried to uncheck the estop but after clicking apply and then ok I tried the reset button and it would not reset. So I went back and checked my estop setting and it was checked with a green check so I unchecked it again now showing a red x click apply and ok again then clicked the rest and it would still not reset. So I opened it again and it had changed itself bach to a green check. So I unchecked it again still the same thing happened.
Any thoughts?
I see that you suggested I look at the vidio and I will do that thanks again.
Thanks
Mike