Messages

1

General Mach Discussion / Re: New Fixture save

« on: October 07, 2006, 09:16:15 PM »

it seems to work ok for me, I ran ver 2 today. There is a couple of things, I have the auto zero checked and my home off is at 0.0100 the dro's do not change to this dimension after using g54. the mach 3 manual says it should. Also after homing if I go into mdi and type in g90 g54 g00 x0. y0 it does not move, it should go to where ever I have g54 setup at.

2

General Mach Discussion / Re: New Fixture save

« on: October 07, 2006, 08:13:28 AM »

Hood I found the answer!! Make sure you dont have selected the option for config/state..copy
G54 from G253 at startup. That could overwrite your saved values.. I copied this from the yahoo group, it seems to work for me so far!!

3

General Mach Discussion / Re: New Fixture save

« on: October 06, 2006, 06:46:10 PM »

Has this been resolved?, I am having the same problem ver 1.84.001 optional offsets are checked as is persistant