1
SmoothStepper USB / Ethernet Smooth stepper and The PMDX-126
« on: November 25, 2014, 02:24:59 AM »
Hi Guys,
I am finally setting up a machine with Mach4.
I messed around with Mach3 a little, but never finished setting up the machine.
I just found out that my Galil controllers are not going to be compatible.
So after doing alot of reading I think I have decided to go wit the Ethernet Smooth Stepper and the PMDX-126
If I am understanding this correctly the combo will allow interfacing to servos also. Is that correct?
I will be using steppers initially, but if I could convert to servos later that would be great.
Any suggestions on this combo?
Thanks,
Joe
I am finally setting up a machine with Mach4.
I messed around with Mach3 a little, but never finished setting up the machine.
I just found out that my Galil controllers are not going to be compatible.
So after doing alot of reading I think I have decided to go wit the Ethernet Smooth Stepper and the PMDX-126
If I am understanding this correctly the combo will allow interfacing to servos also. Is that correct?
I will be using steppers initially, but if I could convert to servos later that would be great.
Any suggestions on this combo?
Thanks,
Joe