Messages

1

General Mach Discussion / Re: LazyCam problems

« on: August 20, 2008, 11:32:10 PM »

Now I have four perfect parts.

Thanks Again Dave,

2

General Mach Discussion / Re: LazyCam problems

« on: August 20, 2008, 09:52:45 PM »

Dave are you a God? If not how do you know these things? I don't know why it worked but it did.


Thank you,
     Steve

3

General Mach Discussion / LazyCam problems

« on: August 20, 2008, 04:22:14 PM »

Could some one do me a favor and run this DXF through LazyCam for me. I can get good code with a .187 inside offset and with no offset  but I get errors when I try with a .187 outside offset. I would be very grateful.

Steve

4

LazyCam (Beta) / Re: Lcam Confusion

« on: October 20, 2007, 09:46:12 AM »

Thanks Shane, I'll give it a try


Steve

5

LazyCam (Beta) / Re: Lcam Confusion

« on: October 14, 2007, 03:01:27 PM »

Shane,

Got the file and loaded it no problem.Thanks for you patients. I still had the same problems though, I dicked around with it for awhile and found that my connection tolerance was to small. I wish there were better instructions.

Thanks yet again,

Steve

6

LazyCam (Beta) / Re: Lcam Confusion

« on: October 13, 2007, 10:05:36 PM »

Shane, 

It seems my brain has stopped functioning just like Lcam. I put half of one Email and half of the other together. Could you, would you try this one?
gt150_74@yahoo.com   I sure would appreciate it. And my most sincere apology's for my brain failure, I guess I shouldn't have stopped my Lithium. 

Thanks Again,

Steve

7

LazyCam (Beta) / Re: Lcam Confusion

« on: October 12, 2007, 11:07:43 PM »

Thanks Shane,
I'm glad to hear it's not just me. Like you I do a lot of offsets and pockets, as you can tell by the DFX.
I don't have a 2.2 Lcam any longer, if it wouldn't be to much trouble, could you Email me a copy of yours?
gt150_74@comcast.net

Thanks much,

Steve

8

LazyCam (Beta) / Lcam Confusion

« on: October 12, 2007, 05:16:52 PM »

Can someone open the attached DFX look at it then open it in Lcam and see if there's extra crap in the upper left hand corner.
After that would you try to pocket the lower inside area, I get nothing. I don't understand ether of these problems.

Thanks,
Steve