Messages

1

General Mach Discussion / Re: Control the Z axis when a program is running.

« on: November 08, 2008, 05:21:44 PM »

I have searched the forum and can not find any good answers. I will check THC box and see if it lets me do that.

2

General Mach Discussion / Control the Z axis when a program is running.

« on: November 07, 2008, 09:47:32 PM »

Hi, I am running a plasma/flame torch on my table and I was wondering if it is possible to run the z axis manually at the  same time mach 3 is running a program? Let me know if this would work.

3

LazyCam (Beta) / Plasma kerf width in Lcam

« on: August 02, 2008, 10:31:38 PM »

Can anyone tell me how to set the plasma kerf width in Lcam. If Lcam doesn't have that can it be done in Mach3?

4

LazyCam (Beta) / Re: Circles from Lcam to Mach 3

« on: June 18, 2008, 10:51:06 PM »

I downloaded and installed the newer versions and all worked great. Thank you for your time

5

LazyCam (Beta) / Re: Circles from Lcam to Mach 3

« on: June 18, 2008, 04:30:19 PM »

Hi Chip,

I downloaded your tap file and it works great. Here is what mine looks like. I will keep at it.

6

LazyCam (Beta) / Re: Circles from Lcam to Mach 3

« on: June 18, 2008, 10:52:19 AM »

Here is the dxf file and the tap file which Lcam created.

7

LazyCam (Beta) / Circles from Lcam to Mach 3

« on: June 18, 2008, 01:19:24 AM »

I can export gcode on a square or rectangle and have it work with lcam but when I import a dxf with circles in it the gcode goes all weird in Mach 3. Help someone