Messages

1

Galil / Re: Mach3 + Galil

« on: September 20, 2006, 11:11:45 PM »

Sweet music to my ears.

I like their products, they explain things well, support is great

mach3 with Galil is going to be a powerful combo

2

Galil / Mach3 + Galil

« on: September 19, 2006, 03:08:36 PM »

I heard Mach3 was going to be able to interface with Galil products.

If so, is there an approximate time frame. I am trying to source
components. If we are talking 6 months away, I will go a different
route but if it's around the corner, I will work in this direction.

Thanks,

Jorge

3

General Mach Discussion / Re: Galil

« on: September 19, 2006, 09:17:05 AM »

Hi,

I am in the middle of sourcing components for my 9x30 lathe retrofit. This is
my first experience with such a project so I am pretty ignorant though learning allot.

I am looking to control the x, z axis as well as the c for use with live tooling.
Art says Mach3 can not control the spindle in G Mode with Grex, he is waiting
on a firmware upgrade.

I have been scoping out the Galil videos, hunting for alternate solutions. Anybody
know if this would be possible with Galil.

Thanks,

Jorge