Hello Guest it is April 18, 2019, 05:01:20 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - inivator

Pages: 1 2 3 4 5 6 7 8 9 10 11 »
1
General Mach Discussion / Re: relay setup in Mach3
« on: August 23, 2011, 07:21:52 PM »
thanks Hood, I'll try it........................

2
General Mach Discussion / relay setup in Mach3
« on: August 23, 2011, 01:33:40 PM »
I have a Probotix relay in a RTR system, four axis.  How do I configure the system to activate a router. Signal out, and what else.

3
General Mach Discussion / Re: NOT HOMING CORRECTLY
« on: August 11, 2011, 02:05:33 PM »
Thanks, I'll try it..

4
General Mach Discussion / Re: NOT HOMING CORRECTLY
« on: August 11, 2011, 01:45:12 PM »
What should the Debounce numbers be set at?

5
General Mach Discussion / Re: NOT HOMING CORRECTLY
« on: August 11, 2011, 12:51:16 PM »
Here is the HML file

6
General Mach Discussion / Re: NOT HOMING CORRECTLY
« on: August 11, 2011, 12:09:24 PM »
Hope this works.

7
General Mach Discussion / NOT HOMING CORRECTLY
« on: August 11, 2011, 11:21:02 AM »
FOUR AXIS PROBOTIX, Y SLAVED TO A.  ON THE INPUT SIGNALS, AS LONG AS I MAKE A++ ACTIVE HIGH, I CAN JOG, MOVE WITH MDI, AND FOLLOW G CODE. WHEN THE SYSTEM HOMES TO X, IT WILL ACTIVATE THE E STOP, BUT WILL NOT MOVE OFF HOME LSWITCH OR "0".

8
General Mach Discussion / Motors not backing off of home limits
« on: August 05, 2011, 06:21:35 PM »
Got the other problems solved, but not need help making the motors back off of home, and zero.

9
General Mach Discussion / Re: Homing and slave axis problems
« on: August 05, 2011, 05:52:47 PM »
thanks, I'll try it.  I can unplug and all axis will jog.

10
General Mach Discussion / Homing and slave axis problems
« on: August 05, 2011, 05:09:52 PM »
Need help please. For some reason when I try to jog Y, which is slaved to A. Nothing seems to work right.

Pages: 1 2 3 4 5 6 7 8 9 10 11 »