Hello Guest it is August 14, 2020, 02:04:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Beams

Pages: 1
1
General Mach Discussion / Re: z after running file
« on: October 02, 2007, 10:34:09 PM »
No Problem on my part. I should have read that section better. I downloaded 2.52. Initial testing shows the problem to be gone.


Mark

2
General Mach Discussion / Re: z after running file
« on: October 01, 2007, 11:42:36 PM »
Thank You!!


Mark

3
General Mach Discussion / Re: z after running file
« on: October 01, 2007, 10:08:26 PM »
I went back to version 2.065 and the problem went away.
Vmax twice you suggested upgrading to version 2.50. Were do I get version 2.50? Is it a future release?


Mark

4
General Mach Discussion / Re: z after running file
« on: October 01, 2007, 12:40:44 AM »
Stepper

5
General Mach Discussion / Re: z after running file
« on: September 30, 2007, 10:59:00 PM »
Sid, The problem is happening even when I run the same part over and over with no offset change. I checked the safe Z settings. I was able to make it better by setting it to incremental rise. Now it only changes things the first time I hit the rewind button. After that it seems to be all right. I was playing with the settings with the mill offline. I will try it with the mill running in a day or 2.
Thanks all for or help

Mark

6
General Mach Discussion / Re: z after running file
« on: September 30, 2007, 05:42:32 PM »
Were do I get 2.50? The 2.48 is the highest I see on the download page.



Mark

7
General Mach Discussion / Re: z after running file
« on: September 30, 2007, 01:34:14 PM »
When I start a part I mount my fixture or plate. I than than set my zeros for x,y,z. I am not running any macros. At the end of the part I press the go to Z button. In 2.42 the Z location for a axis might change and the numbers were random. Now in 2.48 only the Z axis is changing. The distance is not always the same.
This issue is on old files that I have run for years and new ones that I just created yesterday.
I am going to trash the Mach 3 file today and start from scratch with setting up my mill. I always uninstall my old version of Mach before I install the new one. That does not remove all of the preference files and maybe one of them went bad.

Mark

8
General Mach Discussion / Re: z after running file
« on: September 30, 2007, 12:08:40 AM »
This problem started for me when I upgraded to version 2.42 and is still in 2.48. The best I can figure out is that Mach is inserting an offset, but I can't figure out were it is getting the numbers.

9
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 22, 2007, 10:39:21 AM »
There nothing like a stack of 13's.
My Guess is 2,131,313.

Pages: 1