1
General Mach Discussion / Re: New here and have a few questions
« on: September 13, 2006, 04:11:44 PM »
Hi Chris,
Ok I think Im on the right track here, I was looking at my boards and the imput from the controll, The extra board you are talking about would be the jumper board from machine to the pc correct? I have Anilam Electronics servos made by SEM, 140 V and 30 pulse amps will these work with the Mach 3? Is there more that would have to be switched over to make it run? I could take some pics if you want, sorry for all the questions Im just trying to figure out witch way to go either try and fix the machine rs port and use the old crusader m or just go with the mach 3 and have a newer controll. But I need the machine to run asap.
Thanks
Chad
Ok I think Im on the right track here, I was looking at my boards and the imput from the controll, The extra board you are talking about would be the jumper board from machine to the pc correct? I have Anilam Electronics servos made by SEM, 140 V and 30 pulse amps will these work with the Mach 3? Is there more that would have to be switched over to make it run? I could take some pics if you want, sorry for all the questions Im just trying to figure out witch way to go either try and fix the machine rs port and use the old crusader m or just go with the mach 3 and have a newer controll. But I need the machine to run asap.
Thanks
Chad