Hello Guest it is March 29, 2024, 09:29:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - samtc

Pages: 1
1
So, I should make a file name SERVPR.DAT and write all the parameter that you give me.

then, put the file in mach3 directory.

regards

sam.

2
I did try the XML file and the spindle work fine, the x-axis some times it works and some times it does not.
the Y and Z axis are not working at all.

The step motors must be config. a little different than the new Maxnc 15 CL....

regards

sam.

3

I was also told that the Maxnc 15 CL step motor setup has changed a few times in the last five years.

I'm going to try the XML file to see if it works because I alredy try the tick box under config. menu.

thanks for the info.

sam.

4
Hi,
I have a maxnc 15 CL mill, that I'm trying to get to work on mach2 or mach3 (Demo ver. ) because I don't have the disks that came we the maxnc. I can not get the mill to work at all, the only thing that works is the spindle, The step motors do not even moved at all.
Can any-body tell me what can I do to get the maxnc going again? 
Where can I get the pinouts of the maxnc so that I can setup with a mach CNC Controller? or
Does anybody have the setup disk for this machine that would like to shared with me?
The maxnc is about 5 years old.

Thank you.

5
General Mach Discussion / Re: No movement
« on: September 11, 2006, 12:05:57 AM »
Hi, rodney
I am new to the forum and I have Maxnc 15 CL that I try to get going with mach but I had the same problem as you.
did you get your machine to work?
if so can you shared the some information.

Thanks

Pages: 1