Hello Guest it is March 28, 2024, 11:53:17 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PGale

Pages: 1
1
General Mach Discussion / Re: RhinoCAM for Mach3 and one error
« on: May 14, 2008, 06:10:41 AM »
I found the problem was resolved by removing the "0" from the end. I know understand this command to be the initial tool change command.

Is the problem in the number of the tool or something else.

I can change the post file if I know what needs to be written...

2
General Mach Discussion / RhinoCAM for Mach3 and one error
« on: May 13, 2008, 05:14:31 AM »
I can see a post processor for Mach 1 and 2 but not for Mach 3 - is there or does there need to be a separate file for this?

I have been experimenting which RhinoCAM and using Mach 2 post - seems to work OK with one error on every file:

It's a line in the file "N60 G43 0" which causes an error in Mach3. "Bug unknown motion codeline 5"

I'm a noob at all of this - Is it something I'm doing or a problem with the Mach 2 post file?

I think G43 relates to the offset system??? Do I need to define something there???

Thanks,

Paul.

Pages: 1