1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: October 10, 2008, 09:21:13 PM »
Hi,
My name is Gary. I am not new to the group I just have been busy and have not followed it as close as I would like to.
I have two cnc milling machines. The first one is a JET mill/drill that I converted to cnc. I installed ball screws and servo motors to all 3 axes and built the controler box for it using Gecko drives. It is a great little machine.
My second machine is an older Bridgeport Boss4 that I stripped down and built a controller box for it and used servo drives in place of the steppers that were on it. Again using Gecko drives. I use both the machines and at times have them both running together.
Thanks for the great group.
Gary from Portland Oregon
My name is Gary. I am not new to the group I just have been busy and have not followed it as close as I would like to.
I have two cnc milling machines. The first one is a JET mill/drill that I converted to cnc. I installed ball screws and servo motors to all 3 axes and built the controler box for it using Gecko drives. It is a great little machine.
My second machine is an older Bridgeport Boss4 that I stripped down and built a controller box for it and used servo drives in place of the steppers that were on it. Again using Gecko drives. I use both the machines and at times have them both running together.
Thanks for the great group.
Gary from Portland Oregon