1
General Mach Discussion / Re: Estop at wrong times web cam how do i ? help
« on: December 31, 2007, 12:54:55 PM »
Hi Hood
yes i realise we are talking Machine Coordinates,
as i say having now realised that the system when finished reff on an axis that the soft limits become active again then it is obvious that it has to be a 0 as this is what we are setting the Machine Coordinates, to once referenced with the auto zero function
mind you a good lesson in editing code to make it do what you want .
now i just have to find out why the estop trips when i load wizards and when they save g code back to mach 3
i did think it was just the nfg wizards but now found that all do the same
think i need to look at the watchdog signal sent to the break out board see if that stops when saving the data
thanks for you help bill
yes i realise we are talking Machine Coordinates,
as i say having now realised that the system when finished reff on an axis that the soft limits become active again then it is obvious that it has to be a 0 as this is what we are setting the Machine Coordinates, to once referenced with the auto zero function
mind you a good lesson in editing code to make it do what you want .
now i just have to find out why the estop trips when i load wizards and when they save g code back to mach 3
i did think it was just the nfg wizards but now found that all do the same
think i need to look at the watchdog signal sent to the break out board see if that stops when saving the data
thanks for you help bill