Messages

1

Third party software and hardware support forums. / Re: PCI Parallel card NetMos added not reconized...

« on: March 07, 2007, 03:27:30 PM »

I bought it on ebay.. the vendor is in San Francisco.. the brand seems to be unknown.. chineese.. but it is based on an IT8875 chips
When I installed it, it told me that there was a conflict with the address.. I tried to change it... no way... I tried and  everything works fine...

2

Third party software and hardware support forums. / Re: PCI Parallel card NetMos added not reconized...

« on: March 07, 2007, 12:55:01 PM »

thanks Bill.. I tried but the problem was not solved...
Then I bought another // card and this one works well...
It has something to do with the chipset I think...
thank you to all of them...

3

Third party software and hardware support forums. / Re: PCI Parallel card NetMos added not reconized...

« on: March 06, 2007, 10:22:38 AM »

yes... I agree.. it seems that D400 is the address of the port...
But when I try to use it, nothing happens... and worse, the usb mouse is working before launching mach3 but as soon as mach3 is launched, the mouse dissapears and does not work anymore..
what's up ?

4

General Mach Discussion / Re: setting up second parallel port

« on: March 06, 2007, 08:44:50 AM »

Hi !
It seems that we have the same problem... see http://www.machsupport.com/forum/index.php?topic=2496.0

5

Third party software and hardware support forums. / Re: PCI Parallel card NetMos added not reconized...

« on: March 06, 2007, 08:43:16 AM »

for more precision, here are the screen shots of what windows gives about ressources used by lpt ports on my machine :

6

Third party software and hardware support forums. / Re: PCI Parallel card NetMos added not reconized...

« on: March 06, 2007, 04:52:37 AM »

Hi Everybody,
Thanks a lot...
The pc involved is not connected to the internet.. it has only mach3 running on it...
I found something interresting : lpt1 is working fine.. that's the lpt port wich is on the mainboard.. address/ressources are set to 378... the second port on device manager has the address Netmos  (I/O=D400).. what is the correct hexa value for this D400 ?
thanks

Fred

7

Third party software and hardware support forums. / PCI Parallel card NetMos added not reconized...

« on: February 19, 2007, 05:13:18 PM »

Hi !
I added a pci card to get 2 more parallel ports and drive more switches.. I bought a netmos and added it in the pc.. it is reconized by xp as lpt2/lpt3...
When I configure it in mach3, I don't see anything... I checked "use 2nd port", changes and tried all the possible adresses and nothing happens...
I used the little application "port finder" and it sees the 3 ports with the right adresses : 378,278, 3BC..
I don't know what to do now...
Any Idea ?

I must say that I downloaded ComTools to tes the ports... Lpt1 is tested correctly... but LPT2 and LPT3 not... they are PNP in the system config...
Does anyone knows something about adding Netmos card ?