Hello Guest it is January 28, 2022, 11:10:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Keith B

Pages: 1
G-Code, CAD, and CAM discussions / Re: Mach2 Mach3 post differences ?
« on: August 27, 2006, 05:00:29 PM »
Thanks Brian, that now makes sense as to why some g-code would run in Mach2 and not Mach3.

Thanks again!


G-Code, CAD, and CAM discussions / Mach2 Mach3 post differences ?
« on: August 26, 2006, 07:02:37 PM »
I'm trying to get up to speed with Mach2 and Mach3 for my new Tormach that will be here next month. My question is if there would be any fundamental differences between a CAM post for either Mach2 or Mach3. Except of course for any additional features that may be in Mach3 only.

Thanks for any insight on this.



Thanks Brian!


"If you would like I can send you theMach3 post that I use with feature Cam.."

I would love to get a copy of your Mach3 post as well Brian.


Pages: 1