Hello Guest it is March 29, 2024, 08:32:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ymstandard

Pages: 1
1
General Mach Discussion / Using Mach to control XY stage
« on: August 17, 2006, 04:22:41 PM »
Hello to all,

I am building a simple XY stage for positioning/passing samples under a high intensity microwave beam. I need ultra fine control, moving the sample at extremely slow speeds (perhaps even as slow as 1/64" per minute). I also need to ba able to define a particular path for the stage to follow. I am guessing the best way to do this is with some sort of cnc type control.

Would Mach software be good for this? I don't need to do any machining, just positioning/path follwoing. Can a mach screen/interface be simplified to do that?
Also, can Mach drive steppers as slow as I mentioned? (Note: I am looking into a gecko or xylotex controller)


Thanks for your time!

J G

Pages: 1