Messages

1

General Mach Discussion / Re: Tracing eye and mach

« on: August 19, 2006, 09:44:04 AM »

The last time I did any C programming was about 10 years ago, and I sucked!  So I guess I'm screwed!

2

General Mach Discussion / Re: Tracing eye and mach

« on: August 16, 2006, 09:43:05 AM »

Is there any way to integrate the eye into mach?

3

General Mach Discussion / Tracing eye and mach

« on: August 15, 2006, 03:21:10 AM »

I've been given a Burny 3 controller with a tracing eye(and gantry,motors, gear boxes, and drives). I want to run M3 with a MP-1000-THC and gecko's. I'm wondering how I could hook this up so the eye could teach mach a part.

Will I need to keep the burny?

If I need to keep the burny how do I hook up 2 different drives?

What cheap THC options are there that will allow me to just run the burny?


Idealy I would like to run just M3 with an eye and skid the burny control.


Help!!!!!