Hello Guest it is May 16, 2021, 03:13:05 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - phoglite

Pages: 1
1
General Mach Discussion / Re: New to everything, and a big question
« on: August 13, 2006, 02:12:09 AM »
Did you get your mill up and running?  I'm in the same boat and learning more every day.  I just received a taig CNC ready mill with the 4 axis zylotex board and am figuring out how to set this up as I go.  So far, I've got the motors turning but at what feed rate, etc... not sure yet.  I'd be interested in hearing how you got it going!  Thanks, Keith

Pages: 1