1
General Mach Discussion / Re: Plasma tube cutting
« on: December 21, 2010, 07:40:11 PM »I manage to do some holes on the tube by simply substitute "electrically" the axis X servo drive with the axis A servo drive. So i dont have to do any changes at all at the g code.
Is there any way to tell the mach to substitute software wise the output of the X axis to the output of the A axis?
Since you likely won't be cutting sheet and tube on the same job, couldn't you just build a second mach profile for tube cutting? Then it would be as simple as loading the correct "version" of Mach for the job, and you could continue to use your standard g code.