Hello Guest it is March 28, 2024, 10:46:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hunnam

Pages: 1
1
General Mach Discussion / Problem on opening Mach 3
« on: March 15, 2008, 08:56:47 AM »
I have installed Mach 3 and from the moment i open the programme all my motors turn a step every few seconds and I cannot for the life of me stop them.

When I run a G code it all works fine but a few seconds after the g code is finished the motors start turning again every few seconds.

Can anyone help please?

Pages: 1