1
General Mach Discussion / Old MaxNC Controller open Loop two Port
« on: July 27, 2006, 11:51:56 AM »
Hello veryone my name is Milt., I have question:
I have an old max nc controller, that I want to put use. It uses two port Parallel ports. X,Y at address 278, and A,Z at address 378.
My question is ,what Mach product do I use, and how do I set it up?
I have an old max nc controller, that I want to put use. It uses two port Parallel ports. X,Y at address 278, and A,Z at address 378.
My question is ,what Mach product do I use, and how do I set it up?