Hello Guest it is May 25, 2019, 01:44:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Casey

Pages: 1
1
General Mach Discussion / Mach 3 tutorial video cd
« on: March 09, 2008, 11:45:46 PM »
I purchased the Mach3 tutorial cd instead of downloading it on my slow dial up service. It has been very helpful so far. I am having trouble with some of the videos. They seem to in fast forward and are garbled also are very small and hard to read. Others play just fine. I sorry but I don't know which ones they are right now but I can get that info for you if needed. Thanks for your help.

2
General Mach Discussion / Re: Sreen display problems
« on: March 01, 2008, 11:16:25 PM »
Thanks for the reply Hood. I tried your suggestions and had no change. I took my PC to a repair facility and ended up replacing the video card with a higher end video card and all is well now.

3
General Mach Discussion / Spectralight or Inteltek lathe question
« on: March 01, 2008, 11:12:31 PM »
I am setting up a Spectralight lathe now known as Intelitek. I have have removed the original control board and installed an Easy-cnc driver board bought from ebay. From what I have been reading these machines were made by Sherline. Do I need to check the Sherline option in pins and ports to run this lathe? Also how do I connect and program the tool turret? Do I connect it to the Y axis?  Thank you

4
General Mach Discussion / Sreen display problems
« on: March 01, 2008, 07:56:52 AM »
I have down loaded mach3 demo version onto a XP pro desk top PC. All loaded ok but I am getting the top blue bar in several places on the screen mostly on turn manual or auto but also shows up in the reset button area of mill or plasma screen. I have tried to uninstall and reinstall with no results.

Pages: 1