1
General Mach Discussion / Re: mach don't control the spindle switch
« on: March 28, 2008, 06:47:03 AM »
hey, thanks evrybody.. it's working now.
the cause of all this was the MaxNC seting , it overides evrything and i couldn't realise that cause the table was moving fine, i even had diffrent pins for the X motor that's why i loosed x movement when maxnc was disabled.
the cause of all this was the MaxNC seting , it overides evrything and i couldn't realise that cause the table was moving fine, i even had diffrent pins for the X motor that's why i loosed x movement when maxnc was disabled.