Hello Guest it is March 28, 2024, 10:14:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nitromethane1721

Pages: 1
1
Noticed that the wizard will work just fine when running in Mach3 - Mill profile, but when I try using the profile I created, "Taig Mill" it fails to create code.

Is there a quick way to switch between profiles without closing and re-launching?

William in MN

2
Newfangled Solutions Mach3 Wizards / Write Wizard - No code output
« on: July 21, 2006, 10:41:58 PM »
Can some one give me a crash course on using it?  Can't get it to output any code at all.  Must not have something set correctly.

William in MN

3
General Mach Discussion / Re: Upgrade - now dead!
« on: July 16, 2006, 07:06:22 PM »
 :D ;D :D ;D :D ;D :D ;D

It works! It works! It works! It works!

Thank you so very much!!!

Next stop, figgure out how to wire up my home switches, and set the software up to look for them.

William in MN

4
General Mach Discussion / Re: Upgrade - now dead!
« on: July 16, 2006, 06:52:36 PM »
If I do so, will I loose my license key?  Not exactly sure where I put the key...or even where it is stored on the machine.  I will give it a try, and If no dice, will have to ask Art to reissue it.

William

5
Brian,

No, at least I don't think I did.  I left the box checked that asked if I wanted to load the drivers...if I did by accident, how would I reload them or check to see if they are loaded?

William

6
General Mach Discussion / Upgrade - now dead!
« on: July 16, 2006, 05:15:42 PM »
 :'(

I don't understand.  All I did was upgrade to the latest and greatest, and now the little bugger sits motionless.  As I started to explain on a post I found regarding the topic, I got an error "No Driver sensed installed."  "Run Driver test."  That sounds good to me, so I opened up the folder where everything is saved, and try and run the driver test.  The same error message is displayed.  So, I try and install the new 1.90 software in its own folder...great new screen layout!  Same error when installing.  Only this time it won't allow me to even run the Driver Test.  Click the button and nothing...

Please help,  It 'twas working hours ago, but not anymore.

Regards,

William in MN

7
???

I am having the exact problem...everything worked just fine until I tried to upgrade to 1.84.002.  Everything installed great until I got the error "No Driver Sensed Installed.  Run Driver Test."  Tried to run the driver test and get the exact same error.

Installed 1.90.065 to a new folder...same error.  Except now when I go to run the driver test, I get nothing.

And, in the new 1.90 version, I can not get access to the motor tuning screen?

If I remember correctly, is there something I have to do to override an estop, which I don't have on this system?

Regards,

William in MN

Pages: 1