Hello Guest it is July 19, 2019, 11:58:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dcheeks

Pages: 1
1
General Mach Discussion / Re: Where do you live ?
« on: February 26, 2009, 04:10:13 PM »
Peter,

Good idea...here I am at my desk...Cheeks in Columbia,S.C.

2
General Mach Discussion / Where do you live ?
« on: February 24, 2009, 06:18:09 PM »
Just curious where everyone is from....Me...Columbia, South Carolina - USA

3
General Mach Discussion / Re: Running a laptop on Mach 3
« on: February 22, 2009, 09:45:54 AM »
Rich,

Thanks for your help. Looks like this has been well covered by others. Thanks again.

4
General Mach Discussion / Running a laptop on Mach 3
« on: February 22, 2009, 08:48:58 AM »
Hi,

Here's what I got. Just bought a CNC router and will have it in my shop that does not have any heat or air. I need to be able to use a laptop so I can take computer indoors at night. I have seen another person using Mach 3 with a laptop, but I know there are some restrictions. I think I remember the guy telling me that the Dell laptops will not work, but the IBM Thinkpad would. If any one can advise what laptop I should buy to run Mach 3 (Hopefully I can get a cheap one off Ebay) I would appreciate it greatly. Thanks in advance for your help

5
Hello Everyone,
My name is Darrell from South Carolina. Just bought my first CNC yesterday (2-21-09) Looking forward to learning from this group and hopefully in the future I will have a little input for the group.

6
General Mach Discussion / Re: Re: Prices for one-on-one phone tech support.
« on: February 18, 2008, 01:16:04 PM »
I am with Mike & RC...There should be a little support with purchase

Pages: 1