Hello Guest it is March 29, 2024, 10:03:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hoggy

Pages: 1
1
General Mach Discussion / Re: cnc screwcutting???
« on: July 13, 2006, 04:41:46 PM »
Many thanks Hood,
 
This has saved me many hours of searching and head scratching.

Thanks Again
All the best

Steve.

2
General Mach Discussion / Re: cnc screwcutting???
« on: July 13, 2006, 04:31:02 PM »
Great stuff,
Many thanks Hood,
Just so I make sure I get this right both the white and red wire are to +5v,but only the red one goes  through the 220 ohm resistor?,also is it then just a case of having a disc spinning on the back of the chuck with one slot in it i.e 1 pulse per rev,or is it a white painted mark.

Steve.

3
General Mach Discussion / Re: cnc screwcutting???
« on: July 13, 2006, 03:57:06 PM »
Many Thanks Hood,
Have you a diagram of how to wire it into mach 3,as this is something I know very little about.

Steve.

4
General Mach Discussion / cnc screwcutting???
« on: July 13, 2006, 02:31:22 PM »
Hi All,
 
Have just finished cnc taig lathe,petol here in the uk but would very much like to add cnc screw cutting ,am now stuck with the problem of spindle encoder(lack of knowledge) here's the one's I have been looking at,don't know if it will do the job or what one or what one to go for RS Stock no: 301-8442 ,RS Stock no: 303-1192 ,RS Stock no: 455-8020 ,so do these not need a PCI encoder interface card if not how do you wire it all up to mach3 pins,do I need a resister etc,if so which one, a diagram would be a great help. ,sorry for my lack of knowledge  on this, am ok on the machine side of things ex toolmaker but know bugger all about the rest.

Regards Steve

Pages: 1