Hello Guest it is March 28, 2024, 08:41:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rdespins

Pages: 1
1
General Mach Discussion / Re: Pendant?
« on: April 19, 2009, 02:17:17 PM »
Thanks, I may give it a try if I can scoop one up on the cheap =).

Ron

2
General Mach Discussion / Pendant?
« on: April 18, 2009, 09:25:10 PM »
Anyone know if this unit could be used with mach 3?  http://www.axis.com/products/cam_295/

3
General Mach Discussion / Re: mach rezeros on its own
« on: February 09, 2008, 08:02:22 PM »
I suppose I shouldn't say it re-zeros,  it offsets by about 1" positive on the Y axis.  funny you should mention the keyboard,  it's a wireless keyboard and mouse,  perhaps they go out of range and upon getting back into range they mess things up.

4
General Mach Discussion / mach rezeros on its own
« on: February 09, 2008, 07:00:35 PM »
Hi,

I run a K2 CNC router with Campbell designs breakout board and gecko drives with Mach3. 

Sometimes when I run a program, The machine rezeros part way through the program (only after my 4th M zero pause for screwing the work down)  This doesn't happen every time only once in a while, even with the same G-Code.  Could this be noise in my wiring.  I have shielded wires but I haven't grounded the shielding to anything.  Where should I connect the shielding to? (the machine frame? the ground on the breakout box enclosure?)

Thanks for any help,

Ron

Pages: 1