Hello Guest it is September 20, 2019, 05:06:22 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ClintK

Pages: 1
1
General Mach Discussion / Fast Jog but it skips on G-Code
« on: February 05, 2008, 12:52:08 PM »
???I have my motor tuning set to 50 ipm and it runs fine with the jog controls.  But when you run G-Code and the computer takes over, it skips steps on anything greater than 16 ipm.  There basically is no load on my router.  I'm just using a V-bit to carve in wood and only going 1/16" deep.  What is even more strange is that when I change my motor tuning to anything less than 50 ipm it skips when you jog.

Is there any way to get a faster cut speed?  I'd like to go up to at least 25 ipm.  I'm using HobbyCNC kit that includes the driver board and motors.

Thanks,
Clint


Pages: 1