1
General Mach Discussion / Mach 3 enable
« on: March 25, 2010, 09:04:35 AM »
Hi All
Does Mach 3 have the capability to send an enable signal to my drive board. What I want is for my drivers to be powered down before and after I run a program. My drivers are a unipolar with power resistors that are always on. the boards do have an enable pin. the addition of 5 volts shuts the boards down. I searched the Mach settings and could not figure it out. Is it possible?
abheli
Does Mach 3 have the capability to send an enable signal to my drive board. What I want is for my drivers to be powered down before and after I run a program. My drivers are a unipolar with power resistors that are always on. the boards do have an enable pin. the addition of 5 volts shuts the boards down. I searched the Mach settings and could not figure it out. Is it possible?
abheli